Other systems may differ in appearance, but the instructions are the same, except as noted. EpsonNet WebAssist is a utility that runs on a browser. If the same printer model name appears several times on the list, you can identify the printers by checking their MAC addresses, which are found on the status sheet. Check the correct network address and then click OK to add it. If you select No , proceed to step 8. Click EpsonNet EasySetup to start it.

Nom: epsonnet winassist
Format: Fichier D’archive
Système d’exploitation: Windows, Mac, Android, iOS
Licence: Usage Personnel Seulement
Taille: 46.90 MBytes

If there is a server or a router functioning as a gateway, enter the IP address of the server or the router for the gateway address. Removes a network address and its subnet mask from the List box. Click Back to go back to the main menu. Click the Install button located next to EpsonNet Print. Therefore, do not forget the WEP Key you have set. Finally, turn on the device. The default value is 6 seconds.

Epson Color Laser Printer Owner’s Manual: System Requirements; Installing Epsonnet Winassist

Check the print server name. Select the Install from a list or specific location radio button and then click Next. Disconnecting ainassist network storage To disconnect the network drive of the network storage, right-click the network drive icon, and then select Disconnect. These screens may be different depending on the operating system.

Do not turn off the printer until an on-screen message prompts you to do so. If the following screen appears, select the No, not this time radio button, and then click Next. Finally, turn on the device. Select the Search for the best driver in these locations radio button and select the Search removable media wihassist box, and then click Next.


Configuring the Print Server Using EpsonNet WinAssist EasySetup

Registers a network address up to 20 addresses. Select the Select All radio button to search for print servers with all the available connections and protocols, or select the Select Individually radio button to select the preferred connections and protocols. Since the firmware update function is for the support purpose, usually you do not need to use this function. Search options Search Options-IP To search for print servers in other segments, set the specific network address and the subnet mask.

See Search options for more information. The computer to use for the following steps must be in the same segment as the print server. Select the Acquire host name and domain name automatically check box if you want to acquire the host name and the domain name using the DHCP server.

epsonnet winassist

winasssist If you try to add an incorrect network address, the « The network address XXX. The print server does not have a default IP address. We recommend that you select the Reconnect at logon check box. Finally, plug the power cord into a properly grounded wall outlet. Make the following settings. Select Automatic or Manual. See your operating system’s online help for detailed instructions. Winassiist default value is 6 seconds. This is because if you select Automaticthe IP address of the print server changes every time you turn on the printer so that you need to change the printer port setting accordingly.


From the Welcome screen, click Next.

epsonnet winassist

If you try to add the same network address, the « This network address has already been registered » message appears, which indicates this address cannot be added.

Since it takes 2 or 3 minutes to send new settings to the print server, wait until an on-screen message appears to indicate that you can turn off the printer. Specify the drive letter for the connection. Configuring the network interface Note: If you set a larger value, it takes more time to search for the network printers.

The Password dialog box appears. Be sure to use the USB cable that comes with the network interface. Be sure the IP address does not conflict with any other devices on the network. Follow the on-screen instructions. Click Back to go back to the main menu. Change the default Universal Plug and Play device name, if desired.